Welcome Guest Login or Signup

RSS 1.0     RSS 2.0

Total Views: 101 - Total Replies: 0

POSTED BY: haojinming518 on 01/22/2014 17:50:57

Go through every single pair of wires in the bottom with the candelabra in turn; stripping away and quantity of plastic sheath and holding the bare wires against the two wires connected towards the battery compartment. If a bulb does not come on, swap the wires more than.When the bulb comes on, mark the wire that joins ralph lauren shirts the wire marked with electrical tape.Subsequent reduce two four cm pieces of wire, and strip both ends. Twist one end collectively with the marked wire from the battery compartment, and twist the other 1 to join the end with the initial 1.

This gives you three twists of wire from the marked wire from the battery compartment. Push these 3 twists of wire in to the chocolate block to join the marked wires in the structure, in spaces 1, two and three. Repeat this process for the unmarked wires, pushing the twists into spaces four, 5 and 6 to join the other unmarked wires. Each of the lights should now work.ralph lauren dids glue to stick the battery compartment ralph lauren outlet with the chocolate block to the cake board, straight under the trunk on the structure.Cut out assorted sizes of ivy leaves from thin card.

Use a needle to create a hole in each leaf where the stalk will be. Spray paint each sides in the ivy leaves silver and leave to dry.Attack the leaves towards the structure by threading the leaves individually on a quick piece of craft wire, then bend the wire around the network of wires on the tree and twist the craft wire ends together to safe the leaf. Use the biggest leaves at the bottom, gradually ralph lauren shoes smaller sized additional up the candelabra. Also, make sure that the bottom most leaves hide the battery compartment and chocolate block.




*** Ghana Asem ***